Free Shipping to Lower 48 States

	Smarty S-67 for Dodge Cummins Turbodiesel 6.7L (2007-2009) $685.00
	Smarty Jr. 6.7L Dodge   $495.00
	Smarty Tuner 98.5-2002 $649.00
	Smarty JR. 03-07 Common Rail $495.00
	s-06 2003-07 5.9l Smarty Power on Demand $685.00
	Super Sport Revo for Dodge 2003-2007 5.9L Trucks $735.00

The Company

MADS is a new company specialized in the development of Automotive electronic products dedicated to the
performance enthusiast.  Our goal is to deliver the most complete, best performing, yet simple to use products. All of
the  engineering / research & development  / performance software design, is done in house. Nothing is outsourced.
The experience in tuning vehicles with computer controlled fuel-injection systems comes from the racing environment
with high-end tuning solutions.

Combined we bring over 40 years of experience in the electronics / software world to the table. This allows us to set the
highest quality standards possible.  Just to mention one, each single product is tested in all it’s functions individually
before it leaves our facility.

MADS Company has three main concerns :

1)        Product quality
2)        Customer satisfaction
3)        Customer Service

Our products reflect that spirit. We hope you appreciate it when you hold one of our products in your hands.

The Products
The MADS tuning software is well known as CaTCHER software
MADS original products were EPROMs and Flash-EPROMs (or “chips”) which could be installed in place of the
original OEM EPROMs and Flash-EPROMs located in the vehicle’s on-board control module. These chips, just like the
tuners of today, keep the entire vehicle safety and emissions systems intact, but modify the fuel injection settings to
deliver dramatic power, torque and driveability improvements.

Also the fuel consumption is one of the most important points of MADS company research. CaTCHER softwares can
 be used to reduce fuel consumption up to 15% depending on the driving condition. Saving money and reducing the vehicle emissions.

With the advent of OBD-II vehicle control module in the early 1990’s, most domestic vehicle manufacturers installed
under-dash ports (“ALDL ports”) which allowed dealers and service techs to “re-flash” the vehicle's control module to
change engine settings without replacing any chip. So today, instead of chips, MADS company primarily sells
 hand-held tuners which achieve the same dramatic drivetrain improvements, without the hassle of popping the hood,
pulling out the vehicle control module and replacing a chip. Installation is quick and easy, taking about 1.5 up to 4.5 minutes,
 depending on the truck model, and requiring no tools or mechanical skills whatsoever.